Introduction to servesal combinations of reverse osmosis equipment

   Because Ro Equipment has excellent equipment performance and good water output, it is widely loved by everyone. This article will talk about several combinations of Ro System.

Several combinations of Water Treatment System are as follows:

     2. Three-section connection with intermediate booster pump. In areas where water sources are particularly scarce, in order to save water as much as possible, even if the water quality of the water source is poor and the salt content is high, it is hoped to obtain a higher recovery rate.At this time, a high-pressure pump must be installed between each section of the multi-section combination to ensure that the pressure difference reaches the required value of the final goal.

   3. Multi-stage series treatment: When the source water has high salinity and the requirements for reverse osmosis effluent quality are relatively high, a multi-stage series method can be adopted, that is, the first-stage effluent is used as the second-stage influent. Using this water treatment method to operate, the quality of the second-stage drainage water is far superior to that of the first-stage influent water, and can be mixed with the first-stage influent water as influent raw water. In the several-stage series type, equipment such as intermediate water storage tanks and high-pressure pumps are required.

   The above is the introduction of several combinations of reverse osmosis equipment, so you can choose the appropriate reverse osmosis equipment according to your actual use.